Panasonic PT-RZ990, Руководство по эксплуатации, Страница: 57 / 240

Chapter 3 Basic Operations — Switching on/off the projector
ENGLISH - 57
How to remove the power cord
Fig.1
Fig.2
1) Confirm that the <MAIN POWER> switch on the side of the projector is on the <OFF> side, and remove
the power plug from the outlet.
2) Raise the power cord holder fixing the power cord upward. (Fig. 1)
f
Fix the power cord holder by snapping into the projector.
3) While holding the power cord connector, pull out the power cord from the <AC IN> terminal of the
projector. (Fig. 2)
Power indicator
Indicate the status of the power. Check the status of the power indicator <ON (G)/STANDBY (R)> before operating
the projector.
Power indicator <ON (G)/STANDBY (R)>
Indicator status Projector status
Off The main power is switched off.
Red
Lit
The power is switched off. (standby mode)
Projection will start when the power on <
b
> button is pressed.
f
The setting of the projector is as follows.
g
The [PROJECTOR SETUP] menu
→
[QUICK STARTUP] is set to [OFF].
f
The projector may not operate when the light source indicators <LIGHT1>/<LIGHT2> or
the temperature indicator <TEMP> are blinking. (
x
page 203)
Blinking
The power is switched off. (standby mode)
Projection will start when the power on <
b
> button is pressed.
f
The setting of the projector is as follows.
g
The [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [ON].
f
The indicator will change to a red light when the specified time has elapsed after the
projector enters the standby mode if the projector is set as following.
The specified time is the time set in the [PROJECTOR SETUP] menu
→
[QUICK
STARTUP]
→
[VALID PERIOD].
g
The [PROJECTOR SETUP] menu → [QUICK STARTUP] is set to [ON].
f
The projector may not operate when the light source indicators <LIGHT1>/<LIGHT2> or
the temperature indicator <TEMP> are blinking. (
x
page 203)
Green Lit Projecting.
Orange Lit
The projector is preparing to switch off the projector.
The power is switched off after a while. (Changes to the standby mode.)