Panasonic PT-LB51EA, Руководство по эксплуатации

Страница: 32 / 62

E
NGLISH - 32
Settings
POSITION menu
This projector detects its own degree of tilt and corrects
the keystone distortion automatically.
OFF
: Deactive
ON
: Active
This projector detects its own degree of tilt and corrects
the keystone distortion automatically (“
REALTIME
KEYSTONE
”). However, keystone distortion may still
affect the images in some cases (e.g. when the projector
is tilted slightly and the tilt is corrected slowly by hand or
when the screen itself is tilted). In such cases, set
“
REALTIME KEYSTONE
” to “
OFF
” and correct the
vertical keystone distortion manually.
(
S-VIDEO
/
VIDEO
/
COMPUTER
/
COMPONENT
signals
only)
You can move the projected image for fine adjustment.
Press
I H
to move horizontally and
F G
vertically.
(
COMPUTER
signals only)
If you have interference patterns of the projected image,
which is sometimes referred to as moire or noise, you
can minimize it by pressing
I H
to adjust the clock
frequency.
(
COMPUTER
/
COMPONENT
signals only)
If you require further adjustment for the same reason as
the
DOT CLOCK
adjustment, you can fine adjust the
timing of the clock. Press
I H
to adjust.
(
S-VIDEO
/
VIDEO
/480i, 576i, 480p and 576p
COMPONENT
signals only)
You can switch the aspect ratio manually when needed.
Press
I H
to cycle through the options.
REALTIME KEYSTONE
KEYSTONE
Image Operation
NOTE:
• You can correct the distortion ± 30 degrees from the
plane. For a better quality image, installing the projector
with a minimum of distortion is recommended.
• The distortion of the
Main menu
screen is not
correctable.
• The result of the keystone correction will affect the
aspect ratio and the size of the image.
• You can correct the keystone distortion manually when
“
REALTIME KEYSTONE
” is set to “
ON
”.
However, when you turn on the power, the amount of
correction will be reset and “
REALTIME KEYSTONE
”
will function again if the tilt is different from the last time
you used the projector. If you correct the keystone
distortion manually when “
REALTIME KEYSTONE
” is
set to “
OFF
”, the amount of correction will be stored by
the projector even after the power is turned off.
Remote control Control panel
See “Navigating through the MENU” on page 27.
See “Main menu and Sub-menu” on page 28.
POSITION
DOT CLOCK
NOTE:
• If the projecting signal’s dot clock frequency is higher
than 100 MHz, the adjustment may not make a
difference.
•
DOT CLOCK
needs to be adjusted before adjusting the
CLOCK PHASE
.
CLOCK PHASE
NOTE:
• If the projecting signal’s dot clock frequency is higher
than 100 MHz, the adjustment may not make a
difference.
•
CLOCK PHASE
is available with
PC
signals and the
following
COMPONENT
connection.
ASPECT
POSITION
H
V
4:3
16:9
AUTO
S4:3