20
(5) Open the Control Panel Unit.
(6) Activate the Read Point Sensor with your finger
and plug in the Power Cord.
(7) Wait approximately 10 seconds, release the
Read Point Sensor, close the Control Panel Unit
(ADF) and the Printer Cover.
(8) Allow the unit to complete the Firmware Update
(approx. 1-minute). When completed, the unit
will reboot and progress to the Standby Mode.
(9) Unplug the Power Cord.
(10) Remove the Flash Memory Card.
(11) Re-install the Memory Card Cover.
(12) Plug in the Power Cord.
(13) Perform Parameter Initialization.
Control Panel Unit
(5)
(6)