Panasonic MCU-L424, Инструкция по эксплуатации

Страница: 18 / 28

- 18 -
Replace belt whenever beater bar stops turning or a burning rubber smell caused by excessive slippage occurs. Refer to
VACUUM CLEANER CONSUMABLES/ACCESSORIES (page 24) for part number.
F) BELT REPLACEMENT (MC-UL426)
Remove beater bar by carefully lifting
out. Remove worn or broken belt.
Clean beater bar and the end caps
(See BEATER BAR CLEANING,
page 20).
Turn off and unplug the vacuum
cleaner.
Always place paper under nozzle
whenever lower plate is removed to
protect floor.
Place vacuum cleaner in upright
position and turn vacuum cleaner
over to expose lower plate.
1 1 1 2 1 3
Release lower plate by rotating the
lower plate latches to the UNLOCK
position.
Remove lower plate and remove any
residue that may exist in belt area.
Reinstall lower plate. Ensure tabs
are locked into slots. Loop new belt around motor shaft
and beater bar belt groove; see
illustration for correct belt routing.
Reinstall beater bar back into nozzle
housing grooves.
Tabs
1 4 1 5 1 6
Press lower plate onto nozzle and
secure by rotating the lower plate
latches to the LOCK position.
Lower
Plate
Latches
1 7
After reinstalling the beater bar, turn
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
Motor
Shaft
Belt Groove
End
Cap
Slot
Nozzle
Beater
Bar
Belt
Groove