Panasonic MCU-L424, Инструкция по эксплуатации

Страница: 17 / 28

- 17 -
Place the vacuum cleaner in the
upright position standing on the
handle. This will minimize wheel
interference when removing lower
plate.
Remove lower plate by rotating
upward.
Turn off and unplug the vacuum
cleaner. Lay unit on floor with nozzle
flat as shown.
Remove nozzle hose from body by
(1) pressing in locking tab and (2)
sliding up and (3) out of retaining slot.
Replace belt whenever beater bar stops turning or a burning rubber smell caused by excessive slippage occurs. Refer to
VACUUM CLEANER CONSUMABLES/ACCESSORIES (page 24) for part number.
2
1
3
Nozzle Hose
Locking
Tab
E) BELT REPLACEMENT (MC-UL424)
1 1
Four (4)
Screws
1 2 1 3
Always place paper under nozzle
whenever lower plate is removed to
protect floor.
Remove the four screws from the
lower plate.
Reinstall beater bar back into nozzle
by placing end caps into grooves.
After reinstalling the beater bar, turn it
by hand to make sure that belt is not
twisted or pinched and that all
rotating parts turn freely.
Lay unit with nozzle flat as shown.
Remove beater bar by carefully lifting
out and remove worn or broken belt.
Clean beater bar and the end caps
(See BEATER BAR CLEANING,
page 20).
Belt
Motor
Shaft
Beater
Bar
Belt
Motor
Shaft
End Cap
Beater
Bar
Groove
1 4
Carpet/
Bare Floor
Selector
Shaft
Motor
Shaft
Belt
Belt
Groove
1 5 1 6
Place the vacuum in the upright
position standing on the handle.
Reinstall lower plate by (1) aligning
the tabs on the lower plate with the
slots in the nozzle and (2) rotating to
installed position. Ensure tabs
are locked into slots.
2
1
Tabs
Slots
1 7
Loop new belt around Carpet/Bare
Floor selector shaft and belt groove
on beater bar.
Make sure belt is routed in the belt
guide as shown. See illustration for
correct belt routing.
Lay unit on floor bottom up with
nozzle flat.
Install the four screws to the lower
plate.
Route nozzle hose to hose holder.
Align nozzle hose bracket with slot on
vacuum cleaner and slide down until
it clicks into place.
Return the vacuum cleaner to the
upright position before plugging into a
mains socket.
Four Screws
1 8
1
2
1 9