Panasonic KX-TVP200, Руководство по установке

Страница: 57 / 408

INTEGRATING THE VPS WITH PANASONIC KX-T PHONE SYSTEMS
Installation Manual 57
3.3.2 KX-TA Series Programming for Inband Integration via the
Manager's Extension
1.
Enable System Programme [102] for each extension connected to the VPS. Jack 07, or jacks
07 and 08 can be assigned for the VPS as the Voice Mail port.
This parameter is used to tell the KX-TA series which extensions are connected to the VPS.
Ports with this parameter enabled can receive Follow-on ID and touchtone call status
Signalling (busy, answered, disconnect, etc.) if the Voice Mail integration and Touchtone
Integration features are also enabled.
2.
Enable System Programme [103] to turn on Touchtone Integration. On extensions with the
Voice Mail port parameter enabled, the KX-TA series can send codes (touchtones) to
indicate call states; this increases VPS efficiency. Codes apply to all transferred calls;
outside calls only indicate disconnect (provided the KX-TA series is programmed for CPC
Detection, and the Central Office sends the CPC signal). Refer to the Table 11 in Section
3.2.4
PBX Interface Parameters.
3.
Put all extensions connected to the VPS into 1 extension group using System Programme
[600].
Reserve this extension group for these extensions! Do not mix other extensions into this
group.
4.
Enable hunting for the VPS extension groups using System Programme [100].
5.
Set the hunting type for the VPS extension groups to circular using System Programme
[101].
Release Sequence
for Call Waiting * N/A N/A F N/A N/A F F
* Check with manufacturer.
N/A Not Available
(A) Adding "A" for "answer" to the operator and extension transfer eliminates the message:
"You have a call" when the AA transfers a call. The VPS disconnects after line is
answered. Adding "D" for "disconnect" creates a blind transfer.
Table 13
PBX Type
Other
Manufacturers
T308 T616
T1232/
TA series
T96 T336
TD816/
1232
TD500