Panasonic KX-TVP150E, Обзор

Страница: 49 / 849

O-2-6 Overview of VPS Functions
2.2 System Administration
2.2.2 Setting System Parameters
To ensure effective utilization of the system ports and stor-
age capacity, the system administrator should set the fol-
lowing system parameters via the RS-232C port.
RS-232C Parameters
(See Administrator’s Work Sheets: RS-232C)
BAUD RATE is set to 9600 bits per second at the factory.
It can be changed if necessary.
The initial setting for WORD BIT LENGTH is 8, which
can be changed to 7.
PARITY is initially set to “NONE.” It can be changed to
“EVEN” or “ODD” if necessary.
STOP BIT LENGTH is set to 1 at the factory. It can be
changed if necessary.
Telephone Line Parameters
(See Administrator’s Work Sheets: Port Setting)
HOOKSWITCH FLASH TIMING is the duration time for
the hookflash during call transfer. It is initially set to 600
milliseconds but can be changed to match the charac-
teristics of the telephone system (PBX) to which the VPS
is connected.
CALLING PARTY CONTROL (CPC) SIGNAL is the time
required to detect a break in the CPC signal from the PBX.
The break indicates to the VPS that the call has been
terminated. The initial setting is 0 milliseconds (NONE).
This can be changed or even set so that the VPS will not
detect breaks in the CPC signal at all.
DISCONNECT TIME is the duration the VPS remains on
the line after the caller has hung up. From the time the
caller hangs up until the disconnect time has elapsed the
VPS cannot answer any incoming calls on the line. The
initial setting is 2 seconds, and this can be changed.
DIAL MODE can be set to DTMF (tone) or pulse. The
initial setting is DTMF.