Panasonic KX-TCD955EC, Руководство по эксплуатации

Страница: 45 / 64

Chapter 4
45
Multi-Unit User Operations
Registration
Registering a Handset in the Base Unit
You must register the handset in the base unit before use.
1
Handset:
Press .
2
Press
G
or
F
until the arrow points to
“
Program
”, then press
OK
H
.
3
Base unit where handset is to be
registered:
Press and hold
on the base unit
for more than 10 seconds until the in
use indicator (
) lights and a
confirmation tone sounds.
4
Handset:
Press
G
or
F
until the arrow points to
“
Registration
”, then press
OK
H
.
5
Press
G
or
F
until the arrow points to
“
Register H/set
”, then press
OK
H
.
•
The available base unit numbers are
displayed.
6
Press
G
or
F
to select the desired
base unit number 1 to 4, then press
OK
H
.
•
The number is assigned as the base unit
number for the handset.
F
•
Charge the optional handset batteries for about 4 hours before initial use.
•
Make sure that the power is ON (p. 12) and the unit is in the stand-by mode.
•
Register the handset number within 1 minute. If not registered within 1 minute, press on the
handset to cancel the programming mode. Then start again from step 1.
C
7
Enter the base unit password (p. 35).
8
Press OK
H
.
•
“
Please Wait...
” is displayed, then
a confirmation tone sounds.
•
The handset will return to the stand-by
mode. The current connected base unit
number will be displayed.
•
The in use indicator ( ) on the base
unit will go out.
•
To register the handset in more than one
base unit, repeat from step 1 with the
other base unit(s).
•
You can exit the programming mode any time
by pressing
.
•
The base unit number which the handset is
currently in contact with can be displayed in
the stand-by mode (p. 50). Calls (both
incoming and outgoing) can be conducted only
via the displayed base unit (even if the radio
areas overlap with neighbouring base units).
C
0 N e w C a l l s
B a s e 2
P l e a s e W a i t . . .
E n t e r B a s e P I N
: —
KX-TCD955EC(038~047) 99.7.15 2:50 PM Page 45