Panasonic KX-TCD200G, Руководство по эксплуатации

Страница: 9 / 44

Preparation
9
Battery life
After your Panasonic batteries are fully charged,
you can expect the following performance:
Ni-MH batteries (700 mAh)
Hinweis:
L
Actual battery performance depends on a
combination of how often the handset is in use
(talking) and how often it is not in use
(standby).
L
Battery operating time may be shortened over
time depending on usage conditions and
ambient temperature.
Battery replacement
If
7
flashes even after the handset batteries
have been charged for 7 hours, the batteries
must be replaced.
Wichtig:
L
We recommend the use of Panasonic
rechargeable batteries noted on Seite 4. If you
install non-rechargeable batteries and start
charging, the batteries may leak electrolyte.
L
Do not mix old and new batteries.
1
Press the notch on the handset cover firmly
and slide it in the direction of the arrow.
2
Remove the old batteries positive (
S
)
terminal first and install the new ones. See
Seite 8 for battery installation.
Turning the power on/off
Power on
Press
{ih}
for about 1 second.
L
The display will change to the standby mode.
Power off
Press
{ih}
for about 2 seconds.
L
The display will go blank.
Setting the date and time
Wichtig:
L
Confirm that the AC adaptor is connected.
L
Ensure that
w
is not flashing.
1
Press
{j
/OK
}
.
2
Select “
Mobilteileinst.
” , then press
{>}
.
3
Select “
Zeiteinstell.
” , then press
{>}
.
4
Select “
Datum/Uhr eing.
” , then press
{>}
.
5
Enter the current day, month and year by
selecting 2 digits for each.
Beispiel: 17 May, 2005
Press
{
1
}{
7
} {
0
}{
5
} {
0
}{
5
}
.
6
Enter the current hour and minute by
selecting 2 digits for each.
L
You can select “
AM
” , “
PM
” or 24-hour time
entry by pressing
{*}
repeatedly.
Beispiel: 3:30 PM
Press
{
0
}{
3
} {
3
}{
0
}
, then press
{*}
repeatedly until “ 03:30 PM ” is displayed.
7
Press
{j
/OK
}
.
8
Press
{ih}
.
Hinweis:
L
To correct a digit, press
{<}
or
{>}
to move
the cursor, then make the correction.
L
The date and time may be incorrect after a
power failure. In this case, set the date and
time again.
Operation Operating time
While in use (talking) 20 hours max.
While not in use
(standby) 170 hours max.
TCD200G(e-g).book Page 9 Tuesday, February 8, 2005 8:57 AM