Panasonic HDC-SDT750, Руководство по ремонту

Страница: 151 / 176

151
VQT3B18
≥
If the temperature of the battery is
extremely high or extremely low, charging
may take time or the battery may not be
charged.
≥
If the charging lamp keeps flashing, make
sure that the terminals of the battery or the
AC adaptor are not exposed to dirt, foreign
objects or dust, then reconnect them
properly.
Disconnect the AC cable from the AC
outlet when you remove dirt, foreign
objects or dust on the terminals of the
battery or the AC adaptor.
If the charging lamp is still flashing, the
temperature of the battery may be
extremely high or extremely low or
something may be wrong with the battery
or AC adaptor. Contact consumer support.
(
l
170, 171, 172)
≥
If you use the AC adaptor near a radio,
radio reception may be disturbed. Keep
the AC adaptor 1 m (3.3 feet) or more
away from the radio.
≥
When using the AC adaptor, it may
generate whirring sounds. However, this is
normal.
≥
After use, be sure to disconnect the AC
adaptor. (If it is left connected, a minute
amount of current is consumed.)
≥
Always keep the electrodes of the AC
adaptor and battery clean.
≥
Image may be affected when the surface
of the protective glass is contaminated by
water, oil, fingerprints, etc. Wipe the
surface of the protective glass gently with
a dry soft cloth before and after the
recording.
≥
Remove the 3D Conversion Lens from the
unit and place it in the lens storage bag
when carrying.
≥
Do not hold the 3D Conversion Lens when
the 3D Conversion Lens is attached to the
unit.
≥
Do not use or store the 3D Conversion
Lens in the following places since it may
cause a failure or malfunction.
j
In direct sunlight or at the beach in
summer, etc.
j
Areas with high temperature and/or
humidity, or where there is rapid change
in temperature and/or humidity
j
Areas with a lot of sand and dust
j
Areas close to fire
j
Close to air-conditioners and/or
humidifiers
j
Areas where it may get wet
j
Areas with vibration
j
inside a car
≥
When the 3D Conversion Lens has not
been used for a long period of time, check
to see if there is any looseness in the
attachment of the 3D Conversion Lens
and adjust the attachment position before
use.
≥
When not in use, put the lens caps on,
place it inside the lens storing bag, and
store in a place with low humidity.
≥
When requesting a repair of the 3D
Conversion Lens, request a repair of the
unit as well, as the cause of the problem
may be in the unit.
About the AC adaptor About the 3D Conversion Lens
HDC-SDT750&TMT750-P-VQT3B18_mst.book 151 ページ ２０１０年８月２０日 金曜日 午後３時５３分