Panasonic HDC-SDT750, Руководство по ремонту

Страница: 144 / 176

144
VQT3B18
Problem Check points
This unit cannot be
operated though it is
turned on.
This unit does not
operate normally.
≥
Remove the battery or AC adaptor, wait about
1 minute and then reconnect the battery or AC
adaptor. Then about 1 minute later, turn on the unit
again. (Conducting the above operation while the
media is being accessed may damage the data on
the media.)
≥
If normal operation is still not restored, detach the
power connected, and contact consumer support.
(
l
170, 171, 172)
Item other than the
touched one is
selected.
≥
Calibrate the touch screen. (
l
47)
The remote control
does not function.
≥
[REMOTE CONTROL] of the [SETUP] is [OFF].
(
l
49)
≥
The button-type battery of the remote control may
have run out. Replace it with a new button-type
battery. (
l
49)
The remaining time
indication or the
elapsed time
indication is not
shown.
≥
[DISPLAY] of the [SETUP] is [OFF]. (
l
42)
The unit arbitrarily
stops recording.
≥
Use an SD card that can be used for motion picture
recording. (
l
23)
≥
The recordable time may have shortened due to the
deterioration of the data writing speed or repeated
recording and deletion. Using the unit, format the SD
card. (
l
47)
≥
If [AGS] is [ON], record in the normal horizontal
position or set [AGS] to [OFF]. (
l
75)
Auto focus function
does not work.
≥
Switch to Intelligent Auto Mode.
≥
If you are trying to record a scene which is hard to
bring into focus in Auto Focus Mode, use the Manual
Focus Mode to adjust the focus. (
l
36, 89)
HDC-SDT750&TMT750-P-VQT3B18_mst.book 144 ページ ２０１０年８月２０日 金曜日 午後３時５３分