13
VQT3J15
Inserting the battery
Install the battery by inserting it in the
direction shown in the figure.
Insert the battery until it clicks and locks.
Charging the battery
DC input terminal
Connect the AC adaptor to the DC input
terminal.
Connect the AC cable to the AC
adaptor, then the AC outlet.
The status indicator will flash red at an
interval of 2 seconds, indicating that
charging has begun.
It will turn off when the charging is
completed.
Inserting/removing an SD card
Check that the access lamp has gone off.
1)
Open the SD card cover and insert
(remove) the SD card into (from) the
card slot
.
Face the label side
in the direction
shown in the illustration and press it
straight in as far as it will go.
Press the center of the SD card and then
pull it straight out.
2)
Securely close the SD card cover.
Securely close it until it clicks.
Quick Guide
Access lamp [ACCESS]
When this unit is accessing the SD
card or built-in memory, the access
lamp lights up.
Содержание HDC-HS80P
Страница 308: ...1111 1111111111 VFF0718 ...