20
2 in 1 HEPA composite and
deodorizing filter / Dirt sensor
Care and maintenance
Before cleaning
■
Be sure to
disconnect the power
plug.
●
Do not use the detergent other than the neutral one for
kitchen purpose. (Deterioration, deformation or breakage
of plastic parts may occur.)
●
When using chemically treated cloth, follow its instructions.
2 in 1 HEPA composite and
deodorizing filter
<about once every 2 weeks>
Suck the front side with vacuum
cleaner etc.
)Installation and removal instructions → P.10(
To remove dust accumulated on the filter area,
suck with vacuum cleaner etc.
Lay the filter on
newspaper etc.
●
Do not apply excessive force because it is easy
to be damaged. (Pay close attention when
cleaning the back side because it is breakable.)
●
Do not wash with water.
Attention
●
Do not operate without the 2 in 1 HEPA
composite and deodorizing filter.
(It may make it impossible to obtain the effect
to clean air, or may cause failure due to dusts
entering the product.)
●
Safely keep the parts removed from the
product when cleaning. (Otherwise you may
trip over them. Or the parts may be damaged.)
Body, Front panel
<about once a month>
Wipe with a soft wrung cloth.
)Installation and removal instructions → P.10(
Wiping with hard cloth may scratch the surface.
●
Wipe the power plug with dry cloth.
Reference time for the 2 in 1
HEPA composite and
deodorizing filter replacement
(Service parts: P.38)
Replacement period
Conditions
About once every
5 years*
When six cigarettes have been
smoked daily. (Japan Electrical
Manufacturers’ Association
standards JEM1467)
* Filter replacement period may be greatly shortened,
depending on the use environment and conditions.
(For example, smoking is frequent.) When the
effect has faded (for example when odor stays
longer than before), replace the filter.
●
After replacement, fill the date installing the filter
in the label and stick it on the back of the product.
●
Dispose of the used filter as inflammable garbage.
Dirt sensor
<about once every 3 months>
Wipe dirt off the lens with dry cotton swab.
●
Wipe the lens periodically.
(The sensor may not work normally when it is
contaminated with moisture or tar of cigarette.)
Remove the
sensor cover.
Wipe dirt off with dry cotton swab.
Lens (Upper left)
Dry cotton swab
●
Be sure to disconnect the power plug before cleaning
the sensor.
●
Do not insert the cotton swab anywhere other than the lens.
●
Illuminate the area when you do not see clearly.
VXL40M_EN_ARA.indd 20
9/30/2015 2:58:02 PM
