Panasonic EVERVOLT EVHB-I7, Инструкция по установке и эксплуатации

Страница: 5 / 43

When handling battery, adhere to all manufacturer safety instructions!
WARNING!
Only accessories shipped with the inverter are recommended for use.
Using other accessories may result in a fire or injury to the user.
WARNING!
Do not disassemble any parts of the inverter which are not mentioned
in the installation guide. It contains no user-serviceable parts. See
warranty for instructions on obtaining service. Attempting to service
the inverter yourself may result in a risk of electric shock or fire and
will void your warranty.
WARNING!
The inverter input and output circuits are isolated from the enclosure.
This system does not include an isolation transformer and should be
installed with an ungrounded PV array in accordance with the
requirements of ANSI/NFPA 70, NEC 690.41.
Equipment grounding is the responsibility of the installer and must be
performed in accordance with all applicable Local and National
Codes.
WARNING!
Before operating the inverter, ensure that the inverter is grounded
properly. This product must be connected to a grounded, metal,
permanent wiring system, or an equipment-grounding conductor
must be run with the circuit conductors and connected to the
equipment grounding terminal or lead on the product.
WARNING!
When a ground fault is indicated, normally grounded conductors
may be ungrounded and energized or normally ungrounded
conductors may be grounded.
WARNING!
Safety Safety
Keep away from flammable and explosive materials to avoid fire.
Do not install or store the system in a corrosive environment where it
may be exposed to ammonia, corrosive gases, acids, or salts (e.g.:
chemical plant, fertilizer storage areas, tanneries, near volcanic ash
eruption).
WARNING!
EVERVOLT Hybrid inverter only supports a certain type of lithium-ion
battery! (Manufacturer certified battery)
CAUTION!
Risk of electric shock from energy stored in the capacitor.
Never operate on the inverter couplers, the Mains cables, battery
cables and PV cables when power is applied. After switching off the
PV, battery and Mains, always wait for 5 minutes to fully discharge the
intermediate circuit capacitors before unplugging DC, battery and
Mains couplers.
CAUTION!
The unit contains capacitors that remain charged to a potentially
lethal voltage after the
, battery and supply have been MAINS PV
disconnected. Hazardous voltage will be present for up to 5 minutes
after disconnection from the power supply.
CAUTION!
CAUTION!
Possible damage to health as a result of the effects of radiation!
Do not stay closer than 7.87 in/20 cm to inverter for a long time.
CAUTION!
Danger of burn injuries due to hot enclosure parts!
During operation, the enclosure may become hot.
Neither touch the positive nor the negative pole of the connecting PV
device. Never touch both poles at the same time.
WARNING!
5
4