CQ-C8401U/C8301U/C7401U/C7301U
CQ-C8401U/C8301U/C7401U/C7301U
43
English
Tr
oubleshooting,
Error Display Messages
42
Error Display Messages
Display
Possible cause
a
Possible solution
Problem
Possible cause
a
Possible solution
Troubleshooting
The disc is dirty, or is upside down.
The disc has scratches.
a
Eject the magazine.
¡
Check the disc.
¡
Load the disc again.
(After 5 seconds)
To next disc automatically
No operation by some cause.
a
Eject the magazine. If failure persists, press the reset switch on the disc
changer. If normal operation is not restored, call the store where you pur-
chased the unit or the nearest Panasonic Servicenter to ask for repairs.
No disc is in the CD Changer (magazine).
a
Insert discs into the changer (magazine).
The changer has become disconnected from the unit in the changer mode.
a
Verify the wiring.
Note:
Messages in the action and display sections of the error chart vary with changers. Refer to the operating
instructions for the Disc changer for details.
The file is not readable.
a
Eject the disc.
(After 5 seconds)
To next file automatically
CD/MP3/WMA
The disc is dirty, or is upside down.
a
Check the disc.
The disc has scratches.
a
Check the disc.
No operation by some cause.
a
Call the store where you purchased the unit, or your nearest Panasonic
Servicenter.
A WMA file can be copyrighted.
a
The file protected by copyright is not playable.
No disc.
DISC Changer
Display
Possible cause
a
Possible solution
Display
Possible cause
a
Possible solution
XM antenna unconnected.
a
Connect the XM antenna.
Cannot receive XM satellite radio.
a
Verify the wiring.
XM broadcasts unreceivable because of poor receiving conditions.
a
Move to an area where XM broadcasts can be received well.
Error Display Messages
XM T
uner
An error arises in the DVD changer.
a
Check the DVD changer. (“REGION ERROR” etc.)
Channel not in service
a
This channel is not currently in service. Tune to another channel.
Remote control unit
No response to
pressing buttons
The battery is inserted in the wrong direction. A wrong battery is inserted.
a
Insert a correct battery in the correct direction.
The battery is weak.
a
Replace the battery with new one.
The aiming direction of the remote control unit is wrong.
a
Aim the remote control unit at the sensor of the unit and press buttons.
The sensor is exposed to direct sunlight. (The remote control unit may not be
operable when the sensor is exposed to direct sunlight. In such a case, the
system is not faulty.)
a
Block off sunlight to the sensor.
