96
5. P2 Card Fully Recorded
Display window
indication
All 7 bar indicators for remaining MEDIA capacity
start blinking.
WARNING lamp
Continues to light up until an operation is
performed.
Tally lamp
Continues to blink 4 times per second until an
operation is performed.
Viewfinder
The END indicator blinks.
Warning tone
Continues to beep until an operation is
performed.
Warning
description
The P2 cards are recorded to maximum capacity.
Recording/
playback operation
The recording stops.
Countermeasures
Delete the clips in the P2 card or insert a new P2
card.
7. Low Wireless Signal Reception
Display window
indication
No display.
WARNING lamp
Blinks 4 times per second. (During pause and
recording)
Tally lamp
Blinks 4 times per second while recording
continues.
Viewfinder
The WIRELESS RF indicator lights up while
recording continues.
Warning tone
Beeps 4 times per second while recording
continues.
Warning
description
This error indicates poor wireless audio reception
conditions.
Recording/
playback operation
Continues to operate without receiving the
wireless microphone signal.
Countermeasures
Check the microphone power supply and the
reception status of the wireless receiver.
6. Recording Error
Display window
indication
“00:00:00:11” appears in the time code display
field. Even after recording is stopped, this display
continues to blink until the next operation is
performed.
WARNING lamp
Blinks 4 times per second while recording
continues.
Tally lamp
Blinks 4 times per second while recording
continues.
Viewfinder
The REC WARNING indicator lights up.
Warning tone
Beeps 4 times per second while recording
continues.
Warning
description
This indicates a failure either in the P2 card
recording or the recording circuit.
Recording/
playback operation
Recording stops.
Countermeasures
Restart recording. Or, turn the power OFF and
turn it ON again, before starting recording.
8. 1394 (when AJ-YAD800G is attached)
Display window
indication
The 1394 E-
__
indicator in the display window
lights up.
WARNING lamp
Blinks 4 times per second while the WARNING
lamp recording is continuing.
WARNING lamp
Blinks 4 times per second while the TALLY LAMP
recording is continuing.
Viewfinder
In the case of Error Code 92, “1394 INITIAL
ERROR” indicator lights up (during pause and
recording)
For Error Codes other than Error Code 92, or if
REC SIGNAL is set to “1394”, no error is
displayed in the viewfinder.
Warning tone
Beeps 4 times per second while ALARM
recording is continuing.
Warning
description
This indicates a failure of the DVCPRO/DV
connector.
Recording/
playback operation
The operation continues, but input signals to the
DVCPRO/DV connector are abnormal.
Countermeasures
Check the connection between the IEEE1394
cable and the DVCPRO/DV connector, settings of
any external device and menus, and the turn on
the power again.
If the warning indication is still illuminated,
confirm the “Error Codes” in the IEEE1394
interface board instruction manual, and consult
your nearest service center.
#,52:2'PINKUJDQQMࡍࠫ㧞㧜㧜㧡ᐕ㧟㧝ᣣޓἫᦐᣣޓඦᓟ㧢ᤨ㧠㧥ಽ
