– 46 –
ECU AQ
O U T P U T
GAIN
WHITE
BALANCE
AUTO W/B
BALANCE
9
0
-3
CAMERA
TEST
BAR
A
B
PRE
AWB
ABB
MANUAL
AUTO
(dB)
SHUTTER
PAINTING
ON
OFF
ON
1/250
1/125
1/100
1/500
1/1000
1/2000
OFF
ECU
R
B
R
B
MASTER
PEDESTAL
IRIS
ON
OFF
PAGE
ITEM
UP
DWN
ON
SELECT
CONTROL
STORE
SET UP
GAIN
BLACK
-
Connecting the AQ-EC1 Extension Control Unit (Option)
Connecting the AQ-EC1 extension control unit (option) allows a portion of the camera section
functions to be operated by remote control.
When the AQ-EC1 is connected and the POWER switches of the unit and AQ-EC1 are set to ON,
the unit automatically enters remote control mode.
The handling instructions included with the AQ-EC1 describe operations for when the AQ-EC1 is
connected to an AQ series digital camera.
When the AQ-EC1 is connected to the AJ-D910WA, some functions differ, and some features
cannot be used.
|
Notes
{
Á
The POWER switches of the unit and AQ-EC1 must be set to OFF before the 6-pin cable is
connected or disconnected.
Á
When OFF has been set for ECU DATA SAVE on the SUB menu CAMERA SW MODE page
of MAIN menu screen 2 of 4
Á
All adjustments and settings made using the switches and controls on the menu setting section
of the AQ-EC1 are erased when the unit’s POWER switch is set to OFF. Neither is it possible to
save any of the adjustments and settings—except for the menu settings—performed using the
AQ-EC1’s switches and controls on the setup card. However, when the AQ-EC1 is connected
again, these settings return to the AQ-EC1 settings.
(Menu contents set with the menu setting section are saved.)
Á
When ON has been set for ECU DATA SAVE on the SUB menu CAMERA SW MODE page
of MAIN menu screen 2 of 4
The adjustments and settings performed using the switches and controls on the AQ-EC1’s menu
setting area will not be lost even when the unit’s POWER switch is set to the OFF po-sition.
|
Note
{
The functions of the AQ-EC1 are limited as follows.
Á
The STORE switch does not function.
(If the menu settings are changed while the AQ-EC1 is connected to the AJ-D910WA, the new
menu settings are saved automatically as soon as the changes are made.)
Note that the AQ-EC1 gain switch displays
p
3, 0 and 9 correspond to L, M and H, and the
OUTPUT switch settings CAMERA, TEST and BAR to CAM/AUTO KNEE ON, CAM/AUTO
KNEE OFF and BAR for each main unit.
Á
The Synchro scan and Super V modes cannot be used while the AQ-EC1 is connected to the
unit.
Á
The lens iris (IRIS) control of the AQ-EC1 is valid only when the lens iris AUTO/MANUAL selec-
tor is set to AUTO.
6-pin Cable
ECU Connector
AQ-EC1
