– 76 –
Adjusting the White Balance/Black Balance
4
Adjustment is completed after a few seconds (the following message appears) and the ad-
justment value is automatically stored in the memory.
|
Notes
{
Á
Check that the lens connector is connected and that the iris of the lens is set to CLOSE.
Á
During black balance adjustment, the iris automatically goes to the shaded status.
Á
During black balance adjustment, the gain selector circuit switches automatically.
In addition, flicker and noise may appear on the viewfinder screen, but this does not indicate a
malfunction.
Á
The black balance cannot be adjusted while the setting menu is displayed on the viewfinder
screen. Therefore, be sure to set the MENU SET/OFF switch to OFF.
Á
If the black shading is not satisfactory even when the “ABB OK” message appears, open the
“AUTO SHADING” SUB menu page of MAIN menu screen 4 of 4, and adjust the black shading.
(See page 141.)
Á
The black shading adjustment is performed automatically when the AUTO W/B BAL switch is
held down at the ABB position for 10 or more seconds.
Á
When the super gain is set to ON, the black balance is performed at the preset position in the
white balance memory.
Message after adjustment is completed
A B B O K
