- 9 -
∫
Cautions for use
Keep this unit as far away as possible from
electromagnetic equipment (such as microwave
ovens, TVs, video games etc.).
≥
If you use this unit on top of or near a TV, the pictures
and/or sound on this unit may be disrupted by
electromagnetic wave radiation.
≥
Do not use this unit near cell phones because doing so
may result in noise adversely affecting the pictures
and/or sound.
≥
Recorded data may be damaged, or pictures may be
distorted, by strong magnetic fields created by
speakers or large motors.
≥
Electromagnetic wave radiation generated by
microprocessors may adversely affect this unit,
disturbing the pictures and/or sound.
≥
If this unit is adversely affected by electromagnetic
equipment and stops functioning properly, turn this unit
off and remove the battery or disconnect AC adaptor.
Then reinsert the battery or reconnect AC adaptor and
turn this unit on.
Do not use this unit near radio transmitters or high-
voltage lines.
≥
If you record near radio transmitters or high-voltage
lines, the recorded pictures and/or sound may be
adversely affected.
About connecting to a PC
≥
Please use a commercially available cable compatible
with the USB 2.0 standard. Connect a miniB terminal
to this unit.
When connecting to the dedicated Camera Head
(AG-UCK20G)
≥
Always use a genuine Panasonic Camera head option
cable (AG-C20003G (3 m (118-1/8
q
)), AG-C20020G
(20 m (787-3/8
q
)): optional).
When connecting to a network
≥
LAN cable
*
(category 5 or above), max. 100 meters
(328 feet)
* Use of an STP (shielded twisted pair) cable is
recommended.
When connecting to an SDI input/output device
≥
To connect to the SDI IN terminal or SDI OUT terminal,
use a double-shielded BNC cable equivalent to 5C-FB
(commercially-available).
Note on viewing motion pictures/still pictures on an
external monitor
≥
Use a commercially-available High Speed HDMI cable.
If possible, we recommend using a cable with a length
of 3 m (9.84 feet) or less.
Make sure to use the supplied cords. If you use
optional accessories, use the cords and the cables
supplied with them.
Do not extend the cords and the cables.
Do not spray insecticides or volatile chemicals onto
the unit.
≥
If the unit is sprayed with such chemicals, its body may
be marred and the surface finish may peel off.
≥
Do not leave rubber or plastic products in contact with
the unit for a long time.
When you use the unit in a sandy or dusty place
such as a beach, do not let sand or fine dust get into
the body and terminals of the unit.
Also, keep the unit away from sea water.
≥
Sand or dust may damage the unit. (Care should be
taken when inserting and removing a card.)
≥
If sea water splashes onto the unit, wipe off the water
with a well wrung cloth. Then wipe the unit again with a
dry cloth.
When carrying the unit, do not drop or bump it.
≥
A strong impact can break the unit’s casing, causing it
to malfunction.
Cleaning
When cleaning, do not use benzine or thinner.
≥
Using benzine or paint thinners may deform the
recorder and/or cause the surface finish to peel off.
≥
Before proceeding with maintenance, remove the
battery or disconnect the AC cable from the power
outlet.
≥
Use a soft, clean cloth to wipe the recorder. To remove
stubborn dirt, wipe the recorder with a cloth moistened
with kitchen detergent that has been diluted with water
and then use a dry cloth to take up the remaining
moisture.
When you are not going to use the unit for an
extended time
≥
When storing the unit, it is recommended that you
place a desiccant (silica gel) in with it.
About terminal protection
≥
When not using the connecting terminal, please attach
the cover.
Do not allow the cord to drag on the ground or pull a
connected cord along the passage
≥
The cord will be damaged, causing fire or electrical
shock, when the cord gets caught by the feet, excite
will also cause personal injury.
About this unit
The unit and the SD card become warm during
use. This is not a malfunction.
AG-UMR20PJ.EJ(DVQP1321ZA)_E.book 9 ページ ２０１７年５月２２日 月曜日 午後２時１１分
