Before using the unit
16
DVQX2103 (ENG)
∫
LCD monitor and viewfinder
≥
Condensation sometimes forms on the LCD panel of the LCD monitor in locations subject to
extreme temperature differences. If this happens, wipe with a soft, dry cloth.
≥
Do not touch the LCD monitor with your finger nails, or rub or press with strong force.
≥
The LCD monitor will be slightly darker than normal immediately after the power is turned on
when the camera is very cold. It will return to its regular brightness when the internal
temperature increases.
≥
The LCD monitor and viewfinder are managed with high precision so that at least 99.99% of
the dots are effective pixels and 0.01% or less are invalid pixels and always lit. This is not a
malfunction and it has no effect whatsoever on the recorded images.
≥
It may become difficult to see or difficult to recognize the touch when a LCD protection sheet
is affixed.
∫
About Condensation (When the lens, the viewfinder or LCD Monitor is fogged
up)
Condensation occurs when there is a change in temperature or humidity, such as when the
unit is taken from outside or a cold room to a warm room. Please be careful, as it may cause
the lens, the viewfinder or LCD monitor to become soiled, moldy, or damaged.
When taking the unit to a place which has a different temperature, if the unit is accustomed to
the room temperature of the destination for about 1 hour, condensation can be prevented.
(When the difference in temperature is severe, place the unit in a plastic bag or the like,
remove air from the bag, and seal the bag.)
When condensation has occurred, remove the battery and/or the AC adaptor and leave the
unit like that for about 1 hour. When the unit becomes accustomed to the surrounding
temperature, fogginess will disappear naturally.
∫
Caution regarding laser beams
The MOS sensor may be damaged if the MOS sensor is subjected to light from a laser beam.
Take sufficient care to prevent laser beams from striking the lens when shooting in an
environment where laser devices are used.
∫
Regarding system frequencies
You can change the system frequency (59.94 Hz/50.00 Hz) for this unit by using the menu.
≥
When AVCHD clips are recorded, it is not possible to use the same memory card with
different system frequencies. When the system frequency is changed, use a different
memory card.
AG-CX7_CX8_CX10-DVQX2103_eng.book 16 ページ ２０２０年１月６日 月曜日 午後２時４８分
