© Pan Acoustics GmbH
V 1.1
Page 19 of 36
Operating Manual Pan Beam Series
Via the DANTE audio network, it is possible to activate the saved configurations (presets) via
UDP commands.
Calling up presets String (HEX)
Preset 1
50 41 4e 41 43 4f 55 53 54 49 43 53 02 46 46 46 45 52 1c 30 31 1c 30 32 30 32 0d
Preset 2
50 41 4e 41 43 4f 55 53 54 49 43 53 02 46 46 46 45 52 1c 30 32 1c 30 32 30 33 0d
Preset 3
50 41 4e 41 43 4f 55 53 54 49 43 53 02 46 46 46 45 52 1c 30 33 1c 30 32 30 34 0d
Preset 4
50 41 4e 41 43 4f 55 53 54 49 43 53 02 46 46 46 45 52 1c 30 34 1c 30 32 30 35 0d
Preset 5
50 41 4e 41 43 4f 55 53 54 49 43 53 02 46 46 46 45 52 1c 30 35 1c 30 32 30 36 0d
The following control commands must be transmitted completely. It is important to take the below
timing into account. There is no feedback message. All Pan Beam speakers in the audio network
execute the command.
Timing
A wait interval of at least 3 s must be adhered to between the individual commands.
Network address and port
Address: 224.0.1.4
Port: 4712
6.4.7. Media controller
1
2
3
4
6.4.6. Cascading
(4) Pan Beam Net-Link
Via the Pan Beam Net-Link RJ45 port,
additional Pan Beam speakers can be connected with the
AES/EBU interface in a daisy chain procedure.
Pay attention to the proper sequence (Input/Output).
1
2
3
4
Marking (1) to (4)
See chapter 3.2. “Connector panel for Pan Beam PB 04/08/16/24/32/40 - DANTE”
or chapter 3.4. “Connector panel for Pan Beam PB 224 - DANTE”
