04/2010
Einscheibenschleifmaschine UNO, Artikel-Nr. 059629
14
mount the vacuum ring from the lower side of the machine
connect the vacuum ring and the vacuum with the tubes
Use
Mount discs and brushes as described in Item 5.0.
Put the handle (2) in working position with the big, right lever (1).
We recommend to position the hand grip in the height of
the users hip.
Lift the handle slightly, to make sure the machine stands
horizontally.
Press the safety lock (3) at the backside of the grip
Switch on the machine with the respective lever (4).
After switching on the machine, the handle will move shortly to
the right.
The direction in which the machine moves, is controlled by
lifting or lowering the grip. The more you lift or lower the grip,
the faster the machine runs to the corresponding direction.
lifting the grip: machine runs to the right
lowering the grip: machine runs to the left.
If you feel unsafe or cannot control the machine just release
lever (4). The machine will stop at once. If you have carried out
some training, you will be able to operate the machine with one hand.
Always remove discs or brushes after work. Remove also the
cleaning tank, if one has been used. Always disconnect the
power cord after work or when leaving the machine.
Operation with vacuum cleaner
Note: the vacuum cleaner cannot -on technical grounds- remove
the grinding dust from under the discs. It will always remove the
fine dust. To clean the floor use a industrial cylinder vacuum cleaner.
Operation with cleaning tank
Assemble the cleaning tank with 2 supports to the handle.
1.
Check the set
2.
Put the tank a on the lower support
3.
Block A by pushing down the upper support
4.
Insert C as shown in the picture
5.
1. Insert B in the hole on the handle
2. Insert the ring in the lever
6.
Screw the catch on the pushrod
7.
Check that the chain B is not under tension
.
Lever (4) can only be actuated, if the handle is not in
vertical position. This is a safety feature! The user
cannot control the machine with vertical handle.
1
Security latch
2
Switch lever
3
Handle locking device
4
Solution dosing lever
5
Tank / cable support
6
Power cord
7
Accessory socket
1
2
3
4
5
6
2
3
4
1
4
