Pall Allegro MMG403, Инструкция по эксплуатации

Страница: 36 / 53

36
11. Maintenance and Care
The magnetic mixer drive unit is designed to operate with minimal maintenance.
It has been tested to run continuously for up to 7 days. Longer operation may be possible but
further user validation would be required.
To clean, wipe down the drive unit surfaces using water and a mild detergent solution. Standard
drives are constructed from 304-alloy stainless steel, which may be vulnerable to corrosion if
exposed to corrosive chemicals or if left in persistent contact with moisture. Appropriate
precautions should be taken to prevent such corrosion.
Only use the original packaging for shipment of the drive unit.
Recipes can be transferred between magnetic mixer units, including the whole recipe library,
using external media (micro SD card).
If user defined library content needs to be transferred back in the unit after service is done it is
recommended to save the recipe library on a micro SD card prior to conducting software service.
Always unplug the unit from power line when performing maintenance procedures.
When finished, make sure all the electrical cases are properly locked and all
open/detached components placed back and secured in their normal position.
Update/restore of software resets the runtime counters to zero.
Update/restore of software results in changes in recipes content which is set to factory
installed values (run time and pause time are zero, speed = 20 RPM).
The presence of this WEEE label on a product means that the product contains
electrical or electronic materials and therefore must not be disposed of as
unsorted waste but instead is treated separately. The presence of these materials
may, if not disposed of properly, have potential adverse effects on the
environment and human health. Within the European Union, operators are urged
to recycle such products when being replaced with a newer version or when they
have outlived their useful lives.
Under the Waste Electrical and Electronic Equipment (WEEE) directive and
implementing regulations, when customers buy new electrical and electronic
equipment from Pall they are entitled to:
•
Send old items put on the market in Europe before August 13th 2005
equipment for recycling on a one-for-one, like-for-like basis (this varies
depending on the country)
•
Send the new equipment back for recycling when this ultimately becomes
waste.
Country specific instructions to both customers, and recyclers/treatment facilities
wishing to obtain disassembly information, are provided by following the link
below.
https://www.pall.com/en/about-pall/corporate-sustainability/weee-compliance.html