Pall Allegro MMG403, Инструкция по эксплуатации

Страница: 27 / 53

27
Stopping a Manual Mode Job (Permanent Run) 9.5.3.
To stop a manual job that is currently running, press and hold the Stop button. When a job is
stopped the screen will display ‘Successful Finish’ with a time stamp and run duration. To resume
to the manual mode screen press the OK button.
When failure mode is activated during run the job is paused automatically and can be resumed
upon failure reset. ‘Unscheduled Finish’ is displayed with the time stamp and net mixing time after
stopping the run. To resume to the manual mode screen press the OK button.
Stopping a Manual Mode Job (Timed Run) 9.5.4.
Timed runs will automatically stop when the scheduled run time is complete. The screen will
display ‘Successful Finish’ with a time stamp and run duration. To resume to the manual mode
screen, press the OK button.
To stop a timed job that is currently running, press and hold the
stop button. When the job stops
the screen will display ‘Unscheduled Finish’ with a time stamp and run duration. To resume to the
manual mode screen, press the OK button.
When failure mode is activated during a run, the job is paused automatically and can be resumed
upon failure reset. ‘Unscheduled finish’ is displayed with a time stamp and net mixing time after
manually stopping or automatic finishing of the run. To resume to the manual mode screen, press
the OK button.
Pausing and Resuming a Manual Job 9.5.5.
To pause the current job, press and hold the pause button. To resume the job from where it was
paused, press and hold the resume button.
9.6. Remote Mode
The remote mode allows operator to control the magnetic mixer from external equipment to which
the mixer is connected. Supervisor and maintenance user levels can switch the mixer between
remote and local control.
Signal circuits for remote control pass through the control box via two connectors located on the
back of the control box. With a remote control panel, the operator is able to:
•
Start/stop the motor
•
Change the speed of rotation
•
Read the speed of rotation
•
Read alarm status
•
Read the control circuit status
While the magnetic mixer is in remote mode the impeller rotation control is available only via the
remote control unit. The magnetic mixer screen indicates speed of impeller for local monitoring
only. When the control is switched back to local (magnetic mixer) the remote control unit can only
monitor the speed of rotation and alarm status.
When in remote mode the mixer automatically switches to manual mode stop status if any alarm
is activated.
To use the remote mode:
•
Press remote mode on the main menu. The remote mode screen opens in ‘local control’
status indicated in status bar (Figure 31).