Palax Power 100S
Translation
1-2017
32
1. Swing the extension table of the infeed conveyor into the transport position.
2. Remove the support leg A.
3. Remove the lower bearing bracket of the clamp. This makes it possible to turn the
clamp to the side B.
4. Remove the elevation piece C, which is fixed with three bolts to the lower edge of
the infeed conveyor’s left end.
5. Remove the cover plate C, which is fixed with two bolts to the side of the splitting
chute.
6. Remove the old belt, put the new belt into place, and fix in place the bearing
bracket, elevation piece, cover plate and support leg.
7.10 Changing the oil in the angular gear
1. Remove the oil refill plug and drain the used oil.
2. Fill up with about 0.9 litres of new oil.
7.11 Change of the hydraulic oil
The normal hydraulic oil volume is 160 litres.
The quality of oil should be ISO VG 32, e.g. Univis 32, SHELL Tellus 32, NESTE
HYDRAULI 32 or equivalent.
For continuous operation under warm conditions, use ISO VG46.
If a machine powered by electric motor is operated in temperatures below -15 degrees,
it is recommended that a less viscous hydraulic oil be used, e.g. ISO VG 22S multi-
grade oil or synthetic hydraulic fluid, because a machine with electric drive works at full
speed right from the start of operation
Observe particular cleanliness during the oil change, because the flawless operation of
the machine is highly dependent on the purity of the oil.
7.12 Lubricating the machine
The-ball bearings on the centre shaft and the saw-blade shaft. Lubrication interval
about 50 hours and always at the end of the working season if the machine is to be left
standing for a long period of time. Thus the bearings will be soaked with new grease
which efficiently protects them against moisture and corrosion.
Ball-bearings of the operating levers, articulation bearings of the control levers for the
blade every 200 hours, and always at the end of the operating season. If the machine
remains unused for a longer period, the bearings remain filled with fresh grease, which
efficiently protects the bearings against moisture and corrosion.
The log-stop, the support roller for the infeed deck, and the auxiliary deck joints need to
be lubricated
80-hour intervals
using Vaseline spray.
The detent ends of the hydraulic valve spools must be lubricated once a month.
