paladin FFC LAF5689, Руководство оператора и каталог запасных частей

Страница: 13 / 35

MR25661
10
POWER RAKE MOUNTING
WARNING! READ MANUAL PRIOR TO INSTALLATION
Improper installation, operation, or maintenance of this equipment could result in
serious injury or death. Operators and maintenance personnel should read this
manual, as well as all manuals related to this equipment and the prime mover
thoroughly before beginning installation, operation, or maintenance.
FOLLOW ALL
SAFETY INSTRUCTIONS IN THIS MANUAL AND THE PRIME MOVER'S
MANUAL(S).
Loaders
1. Place this product on a firm, level surface that is large enough to safely accommodate this
product, your prime mover and all workers involved in the mounting process.
2. Refer to the operator’s manual(s) for your prime mover, loader, and quick-attach and follow the
mounting instructions contained therein.
3. Carefully raise the loader arms or three point linkage and cycle the tilt cylinders or lower
link arms to check clearances and to verify that all mounting procedures have been
successfully completed.
IMPORTANT
Lubricate all grease fittings before connecting this product to your prime
mover's hydraulic system. Refer to POWER RAKE MAINTENANCE page and
follow the instructions.
3 Point Hitch Category 1 or 2
1. Place this product on a firm, level surface that is large enough to safely accommodate this
product, your tractor, and all workers involved in the mounting process. Making sure this
product is in the operating position and level will facilitate in selecting the proper mounting
holes.
2. Read and understand the Operation and Maintenance manual for your tractor before installing
this product.
3. Remove the top link on your tractors’ 3 point and drive the tractor backwards in to position to
connect the lower links to the attachment mounting ears. The ears have a combination
category 1 & 2 hitch pin installed so you need to make sure the outer pin matches your tractors’
category. Select a hole position on the mounting ears that aligns or is a little above the lower
link points with the tractor link arms fully lowered and connect the arms.
4. The upper link cylinder provided with this product requires a category #2, 1” diameter pin to
attach to the tractors’ upper link point. If you have a category #1 tractor you will have to bush
the pin up to category #2. It is important that when you pin the rod end of the cylinder to the
tractors’ upper link point there is between 4” and 5” of exposed cylinder rod. If you have less
the bucket will not roll back enough and if you have more the bucket will not dump properly.
Move the cylinder pin hole position on the mounting ears until you attain the recommended
amount of exposed cylinder rod.
IMPORTANT
Lubricate all grease fittings before connecting this product to your prime
mover's hydraulic system. Refer to POWER RAKE MAINTENANCE page and
follow the instructions.