Page 12.
-
Do not use elements of
the air pipe in the inlet or
socket of the
device that the manufacturer does not
recommend.
-
When
replacing spare parts, use only the original spare parts
recommended by the manufacturer and do not
use
parts with similar
parameters, this can cause
serious
damage to
the device.
Always
use only the recommended gearboxes
approved by the manufacturer, whose minimum
pressure cannot
be
less than 30 mbar
and
no higher
than 60 mbar.
UNPACKING DEVICES
Unscrew the screw at the end of the lock rod, and
then remove the rod and locked plate.
GENERAL
CHARACTERISTICS OF THE
DEVICE
The hole blows out
the hot air
Open it Box Device и Remove From Her Parts Part Then
Remove Protective Covers from device (e.g.
polostirene or etc.)
-
Remove the protective gas cap immediately
before connecting the gas after installation
work is completed.
-
Make sure
the
device
was not
affected during
transport.
-
If you find any damage, report it to the supplier.
-
After unpacking the instrument, remove the
air flow handle and the fan lock rod.
-
Gas connection kit (flexible hose, filter, faucet)
Rice. 1 External device type
Combined solenoid valve (dual lock)
Gas
connection
Throttle pressure
sensor
Fan failed (off)
Heating (on/off)
Heat Regulator
Connect power
Rice.
Control
Panel
Appearance
Stainless
steel casing
I don't know
points Protective Grille
Fan
Amber
board
