Painless 60608, Руководство по установке

Страница: 37 / 52

36
a. #934 provides battery 12 Volts to the ignition switch. In order for this type of
ignition switch to function properly you are required to splice this wire and
connect it to both terminals as indicated in the diagram. Use one of the butt
connectors from the bubble pack to do this splice.
b. #931 is the coil power wire. In order for this type of ignition switch to function
properly with this harness you are required to install a jumper wire to go
between the
#931 and #933 wires. This jumper wire provides the #933 wire
12 Volts from the #931 wire while cranking the engine.
c. #933 provides 12 Volts to the wiper, turn and gauge/cruise fuses. This wire
also activates the fuel injection relay.
d. #932 provides 12 Volts to the window, a/c-heat and radio fuses.
e. #919 is the engine crank signal wire that connects to the park/neutral switch
and then to the starter if in park or neutral.
6. Dash Mounted Ignition Switch Section
:
Connect the wires for your column mounted ignition switch as the diagram indicates.
Included in the bubble pack are terminals that mate to most dash mounted ignition
switch.
a. #934 provides battery 12 Volts to the ignition switch. Connect this wire to the
battery terminal of your ignition switch.