Painless 60608, Руководство по установке

Страница: 29 / 52

28
Wiring the front of your vehicle:
This section of this harness includes wires for the front lighting circuits, horn,
wiper/washer, cruise control module and electric cooling fans. This section should be
routed over to the driver’s side of the steering column and then out to the engine
compartment through the firewall. A grommet of the appropriate size is included in the
parts kit. Locate where in the firewall you would like the headlight section wires to
protrude through and drill a 1 ¼” hole. De-burr the hole, wrap the bare metal edge with
electrical tape and then feed the headlight section wires through it and out into the
engine compartment. Included in the parts kit and bubble pack are headlight
connectors, terminals, park/turn light sockets and several types of zip ties. Use these
parts where they are applicable to your harness installation. Route the headlight
section wires to the front of the vehicle. Separate the driver’s side and passenger’s side
wires into their own break outs. Loosely zip tie the harness to the driver’s side inner
fender or route it between the inner and outer fenders.
1. Cruise Control Module
The cruise control module connector may need to be routed out through the
same grommet used for the Headlight Section wires. If so, do this now and route
this connector over to the cruise control module and plug it in.
2. Wiper Motor
The wiper motor wires #905 , #978 , #979 and #976 may need to be routed out
through the same grommet used for the Headlight Section wires. If so, do this
now and route the wires up to the wiper motor and window washer motor. If your
wiper and washer motors require the use a different fire wall hole and grommet
please locate it or drill it now. Several grommets are provided in the parts kit.
Find one the right size to fit your hole. Connect the wiper and washer motor
wires as follows. You will find connectors and terminals in the bubble pack that
will fit most wiper motors. If these don’t fit your specific application please use
some of the heat-shrinkable spade terminals that are also in the bubble pack.
a. #905 is the power wire for your wiper and washer motors. This wire will
need to be jumped between the wiper and washer motors in some
applications.
b. #978 is the low speed wire that grounds the low speed circuit of the wiper
motor when the wiper switch is in the low speed position.
c. #979 is the high speed wire that grounds the high speed circuit of the
wiper motor when the wiper switch is in the high speed position.
d. #976 is the wash wire that grounds the washer motor when the wiper
switch is in the wash position.