Painless 60608, Руководство по установке

Страница: 11 / 52

10
Parts required for installation of this harness:
The LS1/LS6 engine and 4L60E transmission section of the wire harness requires the
following parts for proper installation and operation. Factory installed engine sensors,
injectors and coils should be perfect matches for this harness. Do not purchase the
parts listed below unless you are missing it or need to replace a faulty one.
Part Description Part Number
Engine 1997-2004 LS1/LS6 (Mechanical Throttle)
Transmission 1997 & UP 4L60E
PCM (Powertrain Control Module) GM Service #12200411
Fuel Injectors Delphi EV1
Ignition Coils Delco D580
Throttle Position Sensor Delco 213-912
Idle Air Control Delco 217-1806
Engine Coolant Temperature Sensor Delco 213-953
Mass Air Flow Sensor Delco 213-3457
Intake Air Temperature Sensor Delco 213-243
Cam Position Sensor Delco 213-363
Crank Position Sensor Delco 213-354
Knock Sensor Delco 213-3521
Oxygen Sensor Delco AFS97
PRNDL Switch GM #29540479
Vehicle Speed Sensor Delco 213-328
Cruise Control Module GM #25315091
Cruise Control Cable GM #15040802
Manifold Absolute Pressure Sensor Delco 213-331
Mounting the fuse block:
The 26 fuse 7 relay fuse block is the center point of this integrated harness. All power is
routed through this fuse block. The first step to installing this integrated harness is to
mount the fuse block. Remove the front cover from the fuse block.

If looking at the front of the fuse block you will see a mounting hole on the lower
right side. Use a bolt and this hole to secure this fuse block if possible.