Painless 60608, Руководство по установке

Страница: 14 / 52

13
instruction manual, has been designed with five major groups incorporated into it.
These groups are as follows.
Engine section:
This sections wires are to be routed out the center of the firewall, into the engine
compartment, and then to their respective component.
Includes wires and/or connectors that connect to the following: injectors, coils, engine
coolant temperature sensor, alternator, throttle position sensor, idle air control, cam
position sensor, manifold absolute pressure sensor, knock sensors, intake air
temperature sensor, mass air flow sensor, crank position sensor, vehicle speed sensor,
transmission solenoid pack, transmission mounted PRNDL switch, driver and
passenger pre-catalytic converter oxygen sensors, starter, a/c compressor, oil pressure
gauge sending unit, coolant temperature gauge sender and two engine grounds.
Dash section:
Includes fuse block, turn and hazard flashers, a horn relay, an interior ground
connection, and the appropriate wires to connect the following: a/c-heater switch, wiper
switch, ignition switch, headlight switch, turn signal switch, dimmer switch, cruise control
switch, radio, gauge cluster, cigar lighter, courtesy lights, OBD-2 diagnostic port
w/check engine light, driver and passenger power window/lock and speaker wires.
PCM section:
This section is to be routed to the powertrain control module.
Includes blue and red, 80 pin connectors for the powertrain control module.
Headlight section:
This section is to be routed out the driver side of the firewall, into the engine
compartment, and then to their respective components.
Includes wires and/or connectors that connect to the following: high and low beam
headlights, turn lights, park lights, grounds, brake switch, cooling fan 1 & 2, wiper motor,
cruise control module and horn.
Tail section:
This section is to be routed to the rear of the vehicle. You can either route this section
out into the engine compartment and then to the rear of the vehicle or route it under the
door sill plate and then to the rear of the vehicle.
Includes wires that connect to the following: fuel sending unit, electric fuel pump power
wire, reverse lights, left turn/brake/tails, license plate light, right turn/brake/tail lights,
grounds, amplifier activation wire and electric antenna activation wire.
Engine section:
To route the fuel injection engine section of this harness out into the engine
compartment you will be required to drill a 1 5/8
” (41mm) hole in the firewall. Be sure to
de-
burr the hole with a round file and to fold some duct or electricians’ tape around the