Painless Performance Products 66501, Руководство по установке

Страница: 24 / 37

24
TUNE MENU
Shift Points = Sets the RPM at which shifts occur for all shifts. You will be
presented with a menu showing 10% throttle, 40% throttle, and Wide Open
Throttle. Under each is shown shift point RPM. You can adjust each throttle
percentage individually. Changes won’t be saved to the tune until you click
“Save & Exit”.
Firmness = Set shift firmness for all shifts or each
individual shift. Once you’ve chosen a shift to adjust,
you will be presented with a menu showing 10%
throttle, 40% throttle, and Wide Open Throttle. Under
each is shown a number representing firmness. You
can adjust each throttle percentage individually. Changes won’t be saved to
the tune until you click “Save & Exit”.
Tq Conv Cl = This allows you to adjust the minimum RPM for TCC
engagement. Changes won’t be saved to the tune until you click “Save &
Exit”.
DIAGNOSTICS
Dyno Mode = Enable this mode if you are doing a dyno test.
While enabled, you can use the knob to shift gears. Push
the knob to access options, such as enabling torque
converter clutch (TCC) activation above 1800 RPM,
disabling the TCC, and exiting dyno mode.
* Please note that it is not safe to use this mode while driving.
Data Display = Allows you to see readings on the inputs and outputs, such
as Solenoid Ohms and current, PRNDL values, and the voltage or status of
various inputs, such as table select and manutronic. Manutronic, push button
shifting, is not supported with this module. These screens will be helpful
when using the troubleshooting guide or working with our tech support
department. Please note that the solenoid current screen uses the knob to
manually select the current gear, similar to dyno mode. This allows you to
easily verify proper solenoid function in each gear.
Clear Learn = Clicking on this item will allow you to chose which learned
data to clear. You might want to use this if something has changed with the
vehicle or transmission to allow the controller to re-learn the data. The
options are "TCC Learn", "Shift Timing", "All Learning", and "Exit".
Sys Info = Displays firmware and hardware version information as well as
serial number (ID), copyright, and patent information.