32
Low heat with
the knob in
“HIGH”
position.
1. Low heat is found in
2. natural gas models.
2. Ports are blocked.
3. LP tank has run out.
1. This model is set for 7 in. natural gas
usage. Please check your natural gas
supply system to have correct gas
pressure. Regulator is not
needed for NG model.
Check the orifice if you installed NG
nozzles. Conversion kit provides the
following nozzles:
Burner
Orifice Size
Main Burner
Φ
1.8 mm
2. Clear ports of any obstructions.
3. Refill the LP tank.
Low heat,
LP gas.
The propane regulator assembly
incorporates an excess flow
device designed to supply the
grill with sufficient gas flow.
Rapid changes in pressure can
trigger the excess flow device,
providing a low flame and low
temperature.
Please follow these instructions:
1. Make sure all burners are “OFF.”
2. Open the tank valve and wait 5
minutes.
3. Light the burner one at a time following
the lighting instructions listed on the door
liner and Page 25 and 26.
Low heat,
natural gas.
Gas pressure is significantly
affected by gas line and
length of gas line from house
gas line.
Check your gas line and make
corrections by following the chart below:
From House to Grill
Distance
Tubing Size
Up to 25 ft.
3/8 in. DIA
26
– 50 ft.
1/2 in. DIA
51
– 100 ft.
2/3 in. of run 3/4 in.
1/3 in. of run 1/2 in.
Over 101 ft.
3/4 in. DIA
Cooking
light
will not turn on.
1. No power supply.
2. Defective Halogen bulb.
3. Internal wiring issue.
1. Check power supply and make sure it
is properly plugged in.
2. Replace the bulb.
3. Check the wiring connections under
the fire box. All wire connections must be
tight. If any wires are damaged they
should be replaced.
