15
If you cannot stop a gas leak, turn off the gas supply and call your local gas company. If necessary, replace
the faulty part with the manufacturer’s recommended replacement part. A slight leak could cause a fire.
Do not use the grill in garages, breezeways, sheds or any enclosed area. Never operate the grill in
enclosed areas as this could lead to a carbon monoxide buildup, which could result in injury or death. Place
the grill on a level surface. Avoid moving the grill while it is in operation.
NOTE: The grill will operate best if it is not facing directly into the wind
PREPARATION FOR NG CONVERSION:
Before beginning conversion, make sure all parts are present. Compare parts with package contents. If any
part is missing or damaged, do not attempt to convert. Contact customer service for replacement parts.
1. Turn off gas supply, and then remove cap on gas supply side.
2. Recommended: Install a shut-off valve on gas supply side before installing the socket.
3. Socket should be installed by an authorized technician in accordance with the national fuel gas code
(NFPA 54/ANSI223.1).
4. Before inserting plug, turn on gas supply and leak test all connections including the stem of the shut-off
valve and the opening of the socket. For best results, use an ammonia-free soap and water solution
NATURAL GAS INSTRUCTION:
1. To connect, push back socket sleeve (Fig. 1).
2. Insert plug and release sleeve (Fig. 2).
3. Push plug until sleeve snaps forward (Fig. 3). (Gas will
flow automatically. Failure to connect plug properly to socket
will inhibit gas flow to the appliance.)
4. Test connection with ammonia-free soap and water
solution.
To disconnect
1. Pull sleeve back. Pull plug out of socket. (Gas is
automatically shut off.)
2. Close shut-off valve and replace dust caps on socket and
plug.
Place the grill on a flat, level surface.
Before the conversion, make sure all control knobs are in the OFF position, LP tank valve is closed, and
tank is disconnected from regulator and removed from grill.
The plug cannot touch the floor after inserting the plug.
WARNING
Fig. 3
Socket
Sleeve
Sleeve
Socket
Fig. 2
Fig. 1
Socket
Sleeve
Plug
WARNING
