NEO 2.5 INSERT LE_221119-28
9
100003382
Maintenance
WARNING: Never use chemicals or any other volatile liquid to start a fire. Do not burn garbage, or
flammable fluids such as gasoline, naptha, or engine oil.
WARNING: ONLY USE MATERIALS SUPPLIED BY MANUFACTURER WHEN DOING MAINTENANCE OR
REPLACEMENTS.
1. If glass becomes darkened through slow burning or poor wood, it can readily be cleaned with fireplace
glass cleaner when stove is cold. Never scrape with an object that might scratch the glass. The type and
amount of deposit on the glass is a good indication of the flue pipe and chimney buildup. A light brown
dusty deposit that is easily wiped off usually indicates good combustion and dry, well-seasoned wood and
therefore relatively clean pipes and chimney. On the other hand, a black greasy deposit that is difficult to
remove is a result of wet and green wood and too slow a burning rate. This heavy deposit is building up
at least as quickly in the chimney.
2. DOOR GASKETS - The gasket used by Pacific Energy (3/4”(19mm) High density fiberglass rope) requires
only light pressure to seal. This will prolong seal life. It is important that the door seal be maintained in
good condition. Periodically inspect seals and replace if necessary. Follow the instructions included in the
kit, available from your nearest Pacific Energy dealer. See
Replacement Parts List
3. DOOR GLASS - Do not slam loading door or otherwise impact glass. When closing door, make sure that
no logs protrude to impact the glass. If the glass gets cracked or broken, it must be replaced before using
the stove. Replacement glass can be obtained from your dealer. Use 18”(457mm) x 10-1/4”(260mm) x 5
mm. Ceramic glass only. See
Replacement Parts List.
Do not substitute with any other type of Glass.
• To remove broken glass, undo the four retaining screws and remove clamps and frame, noting position for
re-assembly. Remove all particles of glass . Be careful as they are very sharp. Install new glass complete
with gasket. Replace frame, clamps and screws.
CAUTION:
-
Do not overtighten, tighten screws very carefully
- Do not clean glass when hot
- Do not use abrasive cleaners on glass
4. The area where boost combustion air enters the firebox must be kept clear of excessive ash buildup
which will block air flow. This area is at the front of the firebox.
5. Do not store wood within heater installation clearances, or within the space required for fuel loading
and ash removal. Keep the area around the heater clean and free of loose combustibles, furniture,
newspapers, etc.
6. Establish a routine for the fuel, wood burning and firing technique. Check daily for creosote buildup until
experience shows how often you need to clean to be safe.
7. Be aware that the hotter the fire, the less creosote is deposited. Weekly cleaning may be necessary in
mild weather, even though monthly cleaning is usually enough in the coldest months when burning rates
are higher. When wood is burned slowly, it produces tar and other organic vapours, which combine with
expelled
Содержание NEO 2.5 INSERT
Страница 27: ...NEO 2 5 INSERT LE_221119 28 27 100003382...