16
21
#8 x 1/2" screw (2 pcs)
(side rails)
HARDWARE NEEDED
#8 x 3/8" screw (2 pcs)
(motor cover)
HARDWARE NEEDED
24
23
A
A
ASSEMBLY INSTRUCTIONS (cont’d)
Step Eleven:
The grip on the side rail must slide completely inside the control
panel. Install the set screw
w
#8 x ½” into the predrilled hole on the
bottom each side rail as shown. You must drive the screw all of the
way in.
Step Twelve:
Position the motor cover
x
as shown. Use two #8 x 3/8 screws
y
from the hardware kit to secure the motor cover at the two
points. Press down at both points ‘A’ to secure the Velcro pads.
22
