System Operations Manual
www.paceworldwide.com
Page 37 of 40
4. Component Nest Platform alignment. This adjustment is to align the nest to the nozzle.
a. Loosen the 4 allens on the component nest base plate, the 2 allens on the left
adjustment arm, and the one allen on the mechanical stop.
b. Place the component nest platform on the camera housing.
c. Adjust the component nest all the way open.
d. Click on the pickup button. BE PREPARED TO CLICK ON THE STOP HEATER ARM
BUTTON. You want to stop the nozzle above the nest.
e. Now step the nozzle down using the arrows so the corners of the nozzle are just inside
the corners of the nest where the component would normally be.
f.
Adjust the nest closed and adjust the nest position so the corners of the nest are
contacting the corners of the nozzle, front and back.
g. Tighten the base plate allens and the allens on the left are adjustment.
h. Push the mechanical stop against the bearing sleeve and tight that allen.
i.
Click on home.
Figure
Base Plate
Nest
Left adjustment arm
Mechanical stop
