©2022 PACE Inc., Vass, North Carolina, All Rights Reserved Page 6
Handpiece Connection
The MBT360 will work with AccuDrive or SensaTemp hand pieces and tip heater cartridges via the three
channels on its front panel, two for use with AccuDrive hand pieces and one for use with SensaTemp tools.
Caution:
Using handpieces from other PACE product lines may result in damage to the equipment. Only use tip
heater cartridges from the AccuDrive collection (the ones with blue caps on the end). IntelliHeat tip heater
cartridges (black end caps) or WJS-100 tip heater cartridges (yellow end caps) will not operate correctly with the
MBT360.
1. Connect any AccuDrive 4-pin handpiece plug to the power receptacles CH 1 or CH 2 or any SensaTemp
6-pin handpiece plug to CH 3 by doing the following:
a) With the Connector Key end facing the power source, turn the Locking Ring fully
counterclockwise.
b) Orient guide on connector with slot of power receptacle.
c) Insert connector into power receptacle.
d) Turn Locking Ring fully clockwise to lock in place.
2. To avoid confusion among handpieces, PACE recommends the use of colored cable markers (P/N 6993-
0136 Cable Marker Kit) to identify each handpiece and its plug. Attach any two like colored markers, one
to each end of the handpiece power cable or air hose. Select and use a different colored marker for each
handpiece.
3. If you have purchased/received an optional foot pedal, insert the connector plug into the PEDAL
Receptacle on the rear panel of the power source. Install additional handpieces and accessories as
necessary.
System Power
1. Insert the female end of the power cord into
the AC Power Receptacle on the rear panel
of the power source.
2. Plug the prong end (male end) of the power
cord into an appropriate 3 wire grounded
AC supply receptacle.
