Pace Technologies NANO 1000T, Инструкция по эксплуатации

Страница: 11 / 105

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com Web: http://www.metallographic.com
7 Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
NANO 1000T / FEMTO 1500
Polishing Head
3.1 Post Connection
Post
connection: Remove the plastic cover plate from underneath the NANO polisher.
Loosen and swing the Plat Groove for the post so that you can see the post
alignment notch. The post notch must fit into the groove in the brass plate.
Remove plastic cover from the top of the NANO polisher and lower the FEMTO post
into the hole. (note it is recommended to tighten the FEMTO post locking lever first).
Work the post down as far as possible.
The post notch should extend below the NANO casting base. If the post does not
go down all the way align the post with the plate groove and insert bolt/flat washer
and locking washer and tighten so that the post is fully down.
Replace plate and NANO plastic cover.
IMPT: Securing the post is very important and must be done by tightening the bolt/
washer/locker washer from underneath the NANO polisher
Post slot
Post
positioning
Plate Groove
Bottom side post
location on
NANO polisher
Installation (continued)