Pace Technologies NANO 1000T, Инструкция по эксплуатации

Страница: 26 / 105

- - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - ▲
I
NSTRUCTION
M
ANUAL
3601 E. 34th St. Tucson, AZ 85713 USA Tel. +1 520-882-6598 Fax +1 520-882-6599 email: pace@metallographic.com Web: http://www.metallographic.com
22 Please read this instruction manual carefully and follow all installation, operating and safety guidelines.
NANO 1000T / FEMTO 1500
Polishing Head
5.4.1 Programmable Mode
Preset speed buttons
To change the speed setting for
the Preset speed buttons use
the following procedure:
Press the PRG button and use
the Up and Down buttons to SL
(slow speed) and press ENTER.
Use the up and down < key to
change the speed. Use Sn for
changing the medium speed
and SH for the fast speed.
1. The programming mode can be used to pre-set the
polishing speed, direction and time for automated
polishing. It can also be used to change the Preset
speed buttons.
2. To change the speed of the wheel:
Press the PRG button and use the Up and Down
buttons to find SP1 and press ENTER. Use the up and
down < key to change the speed. Press ENTER to
save.
3. To program a grinding/ polishing time:
Press the PRG button and use the Up and Down
buttons to find t1 and press ENTER. Use the up and
down < key to change the time (enter in seconds -
displayed min-sec)
4. To operate the pre-programmed conditions:
PRESS the AUTO button and then start the program
with the RUN/STOP button. The pre-programmed
conditions will be executed.