P1PE P72800A, Руководство пользователя

Страница: 25 / 32

the problem, contact your dealer or the
manufacturer directly. Use only original
parts approved by the manufacturer,
otherwise a hazard risk arises.
ENGINE WILL NOT START
Possible causes;
1. Fuel tank is empty.
2. Fuel tap is in the OFF position.
3. Choke is at the RUN position.
4. Engine switch is in the OFF position.
5. Spark plug dirty/defective.
6. Spark plug wet with fuel (flooded engine).
7. Poor quality fuel; Pressure washer stored
without treating or draining petrol, or refueled
with bad petrol.
8. Low engine oil level.
9. Fuel filter clogged, carburetor malfunction,
ignition malfunction, valves struck, etc.
Possible corrective actions;
1. Refill with clean unleaded petrol.
2. Move fuel tap to ON position.
3. Move choke lever to START position .
4. Turn engine switch to ON position.
5. Check that spark plug wire is connected
properly. Clean or replace spark plug with
properly gapped spark plug.
6. Dry and reinstall spark plug. Start engine with
throttle lever in FAST position.
7. Drain fuel and carburetor and refuel with
fresh petrol. Please contact after sales service
for further assistance.
8. Add engine oil to proper level, see engine
manual.
9. Take engine to your dealer and/or contact
after sales service for instructions.
ENGINE LACKS POWER
Possible causes;
1. Air filter clogged
2. Throttle control is in the slow position
3. Fuel filter clogged, carburetor malfunction,
ignition malfunction, valves struck, etc.
4. Poor quality fuel; Pressure washer stored
without treating or draining petrol, or refueled
with poor quality fuel.
Possible corrective actions;
1. Clean or replace filter.
2. Move throttle control to fast position.
3. Take engine to an authorized servicing
dealer and/or contact after sales service.
4. Drain fuel and carburetor and refuel with
fresh gasoline. Please contact after sales
service for further assistance.
LOW OR SURGING PRESSURE
Possible causes;
1. Insufficient water supply.
2. Blocked inlet screen.
3. Need to use high pressure nozzle.
4. Blocked.
5. Worn nozzle.
6. Leaking high pressure hose.
Possible corrective actions;
1. Increase water flow – check for kinked or
pinched hose.
2. Carefully remove screen and clean.
3. Change to correct nozzles either green,
yellow, white, or red nozzle.
4. Safely remove nozzle as outlined in this
manual and check for blockage.
5. Replace nozzle.
6. Fix leaks if not leaking from hose – NB DO
attempt to repair hose leaks.
NO DETERGENT
Possible causes;
1. Need to use different nozzle.
2. Back pressure from extra-long hose.
3. Leak in clear detergent hose.
4. Detergent strainer not submerged.
5. Detergent strainer blocked.
Possible corrective actions;
1. Change to the BLACK nozzle.
2. Try shorter high pressure hose.
3. Replace hose. Use hose clamps if necessary.
4. Make sure strainer is completely submerged
in solution.
5. Clean detergent strainer.
7. TROUBLESHOOTING
7.1. If troubleshooting does not solve
Page 25 First edition - April 201 7