P1PE P72800A, Руководство пользователя

Страница: 21 / 32

6.3. Spark plug.
The spark plug MUST be fully tightened otherwise the engine will overheat causing and
damage to cylinder head may occur. Always complete the following steps after the engine
has been turned off and allowed to cool down. DO NOT allow any debris to enter the
cylinder.
6.3.1. To remove the spark plug, you must first undo the HT lead then using the supplied
box spanner undo the spark plug (anti-clockwise direction).
Check the condition of the spark plug for signs of wear to the electrodes and carbon
deposits. To removes carbon deposit you can use a soft brass brush. Check the gap of the
plug and make sure it is correctly gapped to a gap of 0.6mm to 0.7mm. You MUST also check
the condition of the washer, if it is damaged it MUST be replaced.
Spark plug tightening for new plug - once washer is sealed turn one extra 1/2 turn, for
existing spark plug with old washer turn an extra 1/8 to 1/4 turn.
Page 21 First edition - April 201 7