Scroll SaW Safety WarninGS
6
Hold power tool by insulated gripping surfaces, when performing an operation
where the cutting accessory may contact hidden wiring or its own cord.
Cutting
accessory contacting a “live” wire may make exposed metal parts of the power tool
“live“ and could give the operator an electric shock.
this appliance is not intended for
use by persons (including children) with reduced
physical, sensory or mental capabilities, or lack of experience and knowledge, unless
they have been given supervision or instruction concerning use of the appliance by
a person responsible for their safety.
children should be supervised to ensure that they don’t play with the appliance.
recommendatins for the use of a residual current device
with a rated residual
current of 30mA or less.
Pull out all nails in the material before starting to saw. Cutting nails may damage
your tool.
Do not operate your scroll saw until it is completely assembled and installed
according to the instructions and until you have read and understood all of the
instructions.
Do not touch moving parts with your fingers or hands.
Ensure that you have tightened the blade prior to starting the machine.
When finishing sawing, wait until the saw blade has ceased moving prior to
removing it from the material.
Do not touch the saw blade immediately after use. Allow time for the blade to
cool, otherwise it could burn you due to the heat generated during sawing.
Always check accessories to ensure that they are suitable for the operating
speeds of this tool.
Incorrect accessories can break apart at high speed and cause serious damage
or personal injury.
Never turn your scroll saw on before clearing the table of all objects (tools,
scraps of wood, etc.) except for the workpiece.
Hold the work firmly against the table.
Do not feed the material too fast while cutting. Only feed the material fast
enough so that the blade will cut.
Never leave the scroll saw running unattended. Always turn the saw off, make
sure that it has come to a complete stop, and then remove plug from the
power supply before leaving the work area.
Use caution when cutting off material which is irregular in cross section as it could
pinch the blade before the cut is completed. A piece of moulding, for example,
must lay flat on the table and not be permitted to rock whilst being cut.
•
•
•
•
•
•
•
•
•
•
•
•
•
