x10
x10
x10
x10
21
Starting the Engine when Warm
When the engine has not been switched off for more
then 15 - 20 minutes.
1. Leave the choke in the run position (Choke Off) and
set the equipment down on a hard, level surface.
2. Set the ignition switch to “ I “.
3. Hold the equipment securely and pull out the starter
cable until you feel it begin to resist. Then tug
sharply on the starter cable until engine starts. If the
engine does not start after 6 pulls, repeat steps 1–7
of the procedure for
“Starting the Engine when Cold”
on page 20.
Switching Off the Engine
•
Emergency Stop procedure
If it becomes necessary to stop the engine , set the
Ignition switch to “0” OFF.
•
Normal procedure
Let go of the throttle lever and wait until the engine has changed to idling
speed. Then set the Ignition switch to “0” OFF.
6. Set the choke lever to choke off position “ ”
(Choke Off/Run).
7. Hold the equipment securely and pull out the starter
cable until you feel it begin to resist. Then tug
sharply on the starter cable until the engine starts.
Note
: Never allow the starter line to snap back. This
may result in damage.
8. Once the engine has started, allow the
equipment to warm up for 10-15 seconds.
Note:
If the engine does not start up, repeat
steps 4-8 above.
9. With the engine running depress the throttle
for operation.
