background image

5 • Oz Charge manual 

 www.ozcharge.com.au

STEP 2 - Pre charge check & electrolyte level check

• 

Check the Battery Electrolyte levels (Not required on sealed & maintenance free batteries or 

Lithium batteries).
If necessary, remove the vent caps and add distilled water so the levels are halfway between 

the upper and lower fill lines. 

• 

Check the battery voltage, type and Ah capacity to ensure the charger is compatible.

• 

Ensure the battery is in a well ventilated area and the charger should be as far away from the 

battery as the cables permit.

Note:

 The Temperature Sensor should be connected to the Negative Battery terminal.

STEP 3 - Connecting the battery charger to your battery

If the battery is still 

in the vehicle

, determine if the vehicle is positively or negatively earthed. 

STEP 4 - Connect the battery charger to Mains Power (240Vac)

• 

The charger will automatically start when AC power is connected and switched on. 

• 

IMPORTANT

: Please double check and make sure the correct Battery Type and your desired 

Charge Rate is selected to suit your battery once the unit is turned on as per STEP 1. 

• 

Note:

 If the Fault Indicator LED illuminates Red, please check your connections as it’s likely 

that the Positive and Negative Leads are reversed.

If the Battery is

 out of the vehicle:

Connect the Red/Orange (+) Crocodile clip or 
ring terminal to the positive (+) battery terminal. 
Connect the Black (-) Crocodile clip or ring 
terminal to the negative (-) battery terminal. 

If 

Negatively Earthed (Most Common)

 – FIRST 

Connect the Red/Orange (+) Crocodile clip or ring 
terminal lead to the positive (+) battery terminal 
and then connect the Black (-) Crocodile clip or ring 
terminal lead to the vehicle’s chassis or negative (-) 
battery terminal. DO NOT connect the Black (-) lead 
to the carburettor or fuel lines.

If 

Positively Earthed 

– FIRST Connect the Black 

(-) Crocodile clip or ring terminal lead to the 
negative (-) battery terminal and then connect 
the Red/Orange (+) Crocodile clip or ring 
terminal lead to the vehicle’s chassis or positive 
(+) battery terminal. DO NOT connect the Red/
Orange (+) lead to the carburettor or fuel lines.

RED

BLACK

RED

CONNECTION IN VEHICLE

(

NEGATIVELY EARTHED

)

RED

BLACK

CONNECTION IN VEHICLE

(

POSITIVELY EARTHED

)

BLACK

RED

BLACK

RED

CONNECTION IN VEHICLE

(

NEGATIVELY EARTHED

)

RED

BLACK

CONNECTION IN VEHICLE

(

POSITIVELY EARTHED

)

BLACK

RED

BLACK

RED

CONNECTION IN VEHICLE

(

NEGATIVELY EARTHED

)

RED

BLACK

CONNECTION IN VEHICLE

(

POSITIVELY EARTHED

)

BLACK

Содержание OC-PRO2500L













Отзывы: