www.oxygenautomation.com
All rights reserved
Pag
.
2
1)
CAUTION! It is important for personal safety
to follow all the instructions carefully. Incorrect
installation or incorrect use of the product could
cause serious harm to people.
2) Read carefully the instructions before
beginning to install the product.
3) Packaging material should not be left near of
children as they are potentially dangerous.
4) Keep these instructions.
5) This product has been designed and built
strictly
for
the
use
indicated
in
this
documentation. Any other use not expressly
indicated could affect the integrity of the product
and / or be a source of danger.
6) Oxygen Automation disclaims all liability
caused by improper use or use other than that
for which the automated system was intended.
7) Do not install the equipment in an explosive
atmosphere: the presence of flammable gas or
smoke are serious safety hazard.
8) The mechanical parts must be in accordance
with the provisions of the Regulations UNI 8612,
CEN pr EN 12604 and CEN pr EN 12605.For non-
EU countries, in addition to national legal
regulations, to obtain an adequate level of safety,
they must follow the regulations above.
9)Oxygen Automationis not responsible for
failure to observe technical standards in the
construction of gates and doors, and if any
deformation occurring during use.
10) The installation must be performed in the
UN18612,CEN pr EN 12453 and CEN pr EN 12635.
The safety of the automation must be C + E.
11) Before carrying out any operations, turn off
the power supply.
12) Equipped automation power net with a
double pole switch with contact opening distance
equal to or greater than 3mm. It is advisable to
use a 6A with pole switching.
13) Check that upstream of the plant there is a
differential switch with threshold of 0.03A.
14) Check that ground system is perfectly
constructed, and connect metal parts of the
closure. Also earth wire yellow / green.
15) The safety devices (Ex .: photocells, safety
edges, etc.) Protect any danger areas against
mechanical movement Risks, such as Ex.
Squashing, conveying and shearing.
16) Each installation must be fitted with at least
one flashing light as well as a warning plate
suitably fixed to the gate, besides the safety
devices.
17) Oxygen Automation accepts no responsibility
regarding safety and correct operation in case of
use of components not Norton Group production.
18) For maintenance, strictly use original parts
Oxygen Automation.
19) Do not in any way modify the components of
the automated system.
20) Installer must supply all information relating
to manual operation of the system in case of
emergency and provide the user the "User
Guide" attached to the product.
21) Do not allow children or adults to stay near
the product during operation.
22) Keep remote controls out of reach of children
or any other pulse generator, to prevent the
operator from being activated involuntarily.
23) The user must not attempt any kind of repair
or direct action whatever and contact qualified
personnel only.
24) Switching between the leaves is allowed only
in completely open gate.
25) Make every six months to verify the system
(safety devices, power actuator thrust, release
device, etc.).
26) Anything not expressly specified in these
instructions
is
not
permitted.
INSTALLER ADVISE
