Rev.0 LEPTON
Service
manual
OXYGEN S.p.A.
5
RECEIVING THE GOODS
On receiving the Lepton check the packaging is not damaged or broken, otherwise
do not accept it, motivating the refuse and communicating it as soon as possible to
OXYGEN.
When removing the packaging, pay attention to the following instructions:
•
Use the proper tools to remove all the metallic clips;
•
Remove the carton around the handlebar;
•
Open the carton on the side up paying attention not to scratch the fairing of
the scooter and taking off the packaging;
•
Remove the nylon cover always paying attention not to scratch the fairing of
the scooter.
After removing the packaging, chek the following parts:
•
Plastic fairing, painted and not painted;
•
Lights and mirrors;
•
Motor
and
driver;
•
Tyres;
•
Suspensions;
For Lepton Pb the battery voltage must be higher than 50 Volt. If it is between 46
Volt and 50 Volt make a complete recharge as soon as you can, if lower than 46 Volt
contact OXYGEN at once.
For Lepton Ni-Zn the battery voltage must be higher than 48 Volt. If it is between 44
Volt and 48 make a complete recharge as soon as you can, if lower than 44 Volt it is
necessary to charge and recharge the batteries about 10 times untill a sufficient
autonomy of the vehicle is reached. In case this procedure is not successful contact
OXYGEN as soon as you can.
STORAGE
Keep the Lepton away from heating and from direct irradiation. Besides, do not
keep the Lepton or its spare parts in wet spaces.
IMPORTANT :
Every two months
at the latest, chek the voltage of the battery pack
and recharge the LEPTON completely. Before this operation chek the battery voltage.
If this is between 46 Volt and 54 Volt recharge completely, if lower than 40 Volt
contact OXYGEN as soon as you can.
