Rev.0 LEPTON
Service
manual
OXYGEN S.p.A.
24
BATTERY CHARGER
The scooter has a high frequency battery charger incorporated in the drive.
The battery charger can be connected to any 110-Volt outlet and is programmed
exclusively for charging the type of batteries used in the scooter automatically.
NOTE:
the charger cannot be used for recharging any other type of battery.
Do not use battery chargers designed for other types of batteries or for batteries with
different voltages or capacities.
CHARGING THE BATTERIES
Recharge the battery:
•
whenever it is low. Delays of more than 24 hours can cause irreversible
damage to the battery.
•
often and completely
•
even if you have only gone a short distance
Only allow the battery charge to run out when it cannot be avoided.
Do not leave the batteries in an uncharged state for even a short period of time.
Only charge the batteries with the battery charger that came with the bicycle or with
one authorized by OXYGEN.
To Recharge the Battery
1. Turn the ignition key to the OFF position.
2. Raise the seat, and connect the cable to the electric outlet.
A flashing or steady light (depending on the battery charge status) on the
instrument panel indicates that the battery recharger is in use.
•
Rapid flashing:
first phase
•
Slow flashing:
second phase
•
Fixed light:
third phase
•
Light off:
end of charge/buffer phase
The scooter cannot be started while the battery is being charged.
The drive is automatically placed in
stand by
mode and the abbreviation
stby
appears
on the LCD strip of the speedometer.
While the batteries are recharging, do not touch the drive. The surface temperature
could reach 140 degrees Fahrenheit.
