Ovention Double MiLO2-16 Скачать руководство пользователя страница 3

Form No. OVMILOM-0718

3

IMPORTANT SAFETY INFORMATION

WARNING

FIRE HAZARD: 

  •  Install with a minimum of 1″ (25 mm) of space from 

control side and rear of unit to any surface.  Install with 

a minimum of 7″ (178 mm) of space from non-control 

side of unit to a combustible surface or with a minimum 

of 2″ (51 mm) of space from non-control side of unit 

to a non-combustible surface. If safe distances are not 
maintained, discoloration or combustion could occur.

  •  Install on non-combustible surface if used without legs 

or casters.

  •  Do not block or cover any cabinet venting.

  •  Do not use an extension cord. If power cord is too 

short, contact a qualified electrician to determine and 
install proper voltage and size electrical receptacle 
near unit.

Make sure all operators have been instructed on the safe 
and proper use of the unit.

This unit is not intended for use by children or persons 
with reduced physical, sensory, or mental capabilities. 
Ensure proper supervision of children and keep them 
away from the unit.

This unit has no “user-serviceable” parts. If service is 
required on this unit, contact an Authorized Ovention 
Service Agent or contact the Ovention Hotline at 

 

855-298-6836.

CAUTION

BURN HAZARD:
  •  Some exterior surfaces on unit will get hot. Avoid 

unnecessary contact with unit.

  •  Pan/tray will be very hot upon removal—use oven mitt, 

pan gripper, or other utensil to remove.

Do not turn off GFCI switches or unplug unit immediately 
after use. Internal fans must cool oven to avoid damage to 
electrical components.

Locate unit at proper counter height in an area that is 
convenient for use. Location should be level to prevent 
unit or its contents from falling accidentally and strong 
enough to support the weight of the unit and contents.

DO NOT lift unit by door handles on front of oven. Door 
handles are not designed to support weight of unit. Lift 
from underneath unit only.

Do not move or relocate unit for cleaning. Unit is bulky 
and heavy.

Do not place anything on top of unit; doing so may subject 
personnel to injury or could damage unit.

Do not heat sealed containers or products such as whole 
eggs in oven. These items may explode.

Do not store any materials or items inside oven chamber 
when not in use.

Never use steel pads, wire brushes, or scrapers to clean 
unit.

WARNING

ELECTRIC SHOCK HAZARD:
  •  Plug unit into a properly grounded electrical receptacle 

of the correct voltage, size, and plug configuration. If 
plug and receptacle do not match, contact a qualified 
electrician to determine and install proper voltage and 
size electrical receptacle.

  •  Unit must be grounded properly. Failure to ground unit 

properly could result in serious personal injury or death.

  •  Place unit in standby, allow unit to cool, turn off both 

GFCI switches, turn off both Control Reset switches, 
and unplug unit before performing any cleaning, 
adjustments, or maintenance.

  •  DO NOT submerge or saturate with water. Unit is not 

waterproof. Do not operate if unit has been submerged 
or saturated with water.

  •  Unit is not weatherproof. Locate unit indoors where 

ambient air temperature is a minimum of 70°F (21°C).

  •  Do not steam clean or use excessive water on unit.

  •  This unit is not “jet-proof” construction. Do not use 

jet-clean spray to clean this unit.

  •  Do not clean unit when it is energized or hot.

  •  Do not clean unit with metal scouring pads. Metal pieces 

can break off pad and touch electrical components, 
creating risk of electric shock.

  •  Do not pull unit by power cord.

  •  Keep power cord away from heated surfaces.

  •  Do not allow power cord to hang over edge of counter.

  •  Discontinue use if power cord is frayed or worn.

  •  Do not attempt to repair or replace a damaged power 

cord. Cord must be replaced by an Authorized Ovention 
Service Agent or a person with similar qualifications.

  •  This unit must be serviced by qualified personnel only. 

Service by unqualified personnel may lead to electric 
shock or burn.

  •  Use only Genuine Ovention Replacement Parts when 

service is required. Failure to use Genuine Ovention 
Replacement Parts will void all warranties and may 
subject operators of the equipment to hazardous 
electrical voltage, resulting in electrical shock or burn. 
Genuine Ovention Replacement Parts are specified to 
operate safely in the environments in which they are 
used. Some after-market or generic replacement parts 
do not have the characteristics that will allow them to 
operate safely in Ovention equipment.

EXPLOSION HAZARD: Do not store or use gasoline or 
other flammable vapors or liquids in the vicinity of this or 
any other appliance.

Install unit in accordance with installation instructions in 
this manual.

This oven is designed specifically to heat or cook—NOT 
for industrial or laboratory use.

In the event of emergency, unplug unit.

Unit may be located adjacent to a slippery floor.

Read the following important safety information before using this equipment to avoid  

serious injury or death and to avoid damage to equipment or property

.

Содержание Double MiLO2-16





















Отзывы: