Instruction Manual
13
Programming the Amplifier for Advanced Operation
Step 1
Power up both the
OAW3-t Transmitter
and OAWA3-r Receiver/
Amplifier. Establish link
between two. If more
than one Amplifier
is to be linked to the
Transmitter, make sure
that only the Amplifier
of interest is powered
and linked for pro-
gramming at a time.
Step 3
Press desired MODE button: Left, Right, or Mono. LED will be-
come steady Blue, confirming selection.
Step 4
Press and HOLD the
"PRO" button for ap-
proximately 5 seconds
until the LED flashes
BLUE, then it will
return to steady-state
BLUE.
Step 5
Repeat Steps 1-4 for each OAWA3-r Receiver/Amplifier to be programmed. Remember,
only the Receiver/Amplifier to be programmed should be powered at this time. When
programming is completed, all Receiver/Amplifiers may be powered on.
Step 2
Press and HOLD the
"PRO" button for ap-
proximately 5 seconds
until the LED flashes RED.
Programming for Advanced Operation
